Wall Decoration - Drago Florido (Tree of Life)

A dragon tree at the moment it blooms
The dragon trees of the Canaries flower only rarely, slowly, as if marking an occasion. The Drago Florido holds on to that moment: a round tree of life in matte black that greets you from the wall, calm and full of presence. The gnarled trunk opens into a canopy studded with small flowers, and below, the roots spread as if embracing the earth, all framed by a clean ring. A compact piece of about 24 cm that fills the corner without cluttering it: life, cycle and flower, all in a single circle.

A canopy full of flowers
This is the detail that makes it special: the canopy is not a solid mass but dozens of small openwork flowers, each with its own rays, like tiny suns among the branches. The matte-black finish stands out elegantly on any wall colour and, with light from the side, casts a soft shadow that draws the tree once more. Ideal for the living room, the hallway or a reading corner, and a piece with real soul for anyone who loves natural, meaningful decor.

Our own design, from our workshop
The Drago Florido is our own design: we draw it and print it for you in Icod de los Vinos (Tenerife), to order, inspired by the dragon trees that grow on the island. It is made of PLA, a plant-based, biodegradable bioplastic. At just 3 mm thick it is very light, so you can hang it anywhere without drilling: with double-sided tape or with adhesive putty at several points. If you'd rather use a nail, that one does need drilling.

Specifications

• Material: PLA (polylactic acid), a plant-based, biodegradable bioplastic

• Size: approx. 24 × 24 × 0.3 cm (round, flat piece)

• Colour: matte black (as shown in the images)

• Technology: FDM 3D printing

• Lightweight, openwork structure, finished product

Mounting & care

• Mounting: without drilling, with double-sided adhesive tape or with adhesive putty at several points; being light, it needs no drilling that way. If you'd rather use a nail, that one does need drilling. Tell us in the order notes which you prefer.

• Indoor decorative item. PLA is heat-sensitive: keep it out of direct sun and off radiators (above 50 °C it can deform).

• Cleaning: clean it with a soft cloth, or with lukewarm water and a little soap.

• The fine print lines are inherent to 3D technology and part of its modern texture, not a defect.